E32 – Overheat signal (STEP1)

Discussion forum and troubleshooting help for Cat/Mitsubishi forklifts E-32 error code.

One thought on “E32 – Overheat signal (STEP1)”

  1. Andy Guild

    Andy Guild

    Your forklift is picking up a higher than desired operating temperature. The first steps are to clean the radiator of any debris and check the coolant level. Once that is done disconnect the battery over night and see if the codes has cleared. If not you may have a bad temp sensor sender or another issue within the cooling system.

Leave a Reply

Your email address will not be published. Required fields are marked *