Attribute | Value |
---|---|
Make | Mitsubishi |
Model | EDR18N2 |
Forklift Type | Reach Truck Forklift |
Basic Capacity (lb/kg) | 3500/1580 |
Load Center (in/mm) | 24/600 |
Power | Electric |
Tilt (forward/back) | 3/4 degrees |
Overall Length (in/mm) | 78.1/1983 |
Length to Fork Face (in/mm) | 62.3/1582 |
Height to Top of Overhead Guard (in/mm) | 95/2413 |
Minimum turning radius (in/mm) | 70.74/1797 |
Weight without battery (lb/kg) | 740/3350 |
Wheelbase (in/mm) | 61.5/1562 |
Tire Size - Steer | 13.5x5.5" |
Tire Size - Caster | 7.0x4.0" |
Tire Size - load wheels | 5.0x3.62" |
Andy Guild –
Use this section to ask questions and leave comments about the Mitsubishi EDR18N2 forklift.
Leng Moua –
Hey, I drive one of these for work but I keep getting code 1120.01 and apparently no one knows what this code means, including the tech who came out here for it. It doesn’t show up in the machines error log eirh
Andy Guild –
I think this is the error you’re getting:
Drive wheel slip excessive
Excessive slip / drive has probably been tipped
The AC-3 Power Control (U8) has detected excessive
deviation (slip) between the phase current frequency and
the speed.
The activation limit is 20 msec.
More torque is required from / placed on the motor than it
can provide / accept;
Field current is reduced excessively;
Error accompanying sensor bearing control or output
stage protection;
Operating system does not allow enough slip for the
driven motor;
AC-3 Power Control component is damaged
– Check motor connection wire (wire breakage);
– Check motor model, replace if necessary;
– Check motor and replace if necessary;