Anyone have the electrical schematic for the accelerator sensor I was getting the e24 code and I replaced the sensor itself and I reset the codes and stuff and it’s still coming up to e24
I just purchased a 2012 nissan 40 forklift to use very little.
It was delivered Saturday and here Monday I was going to move a couple pallets of lumber around . And it flashing error code e24 . Idling a little higher but won’t shift out of neutral. Any thoughts?
You can check the accelerator pedal connection to the wiring harness. Should be connected just below the floor plate – check for looseness, debris and corrosion. There may also be a stop screw to adjust pedal travel that is out of range. And the accelerator pedal might have gone bad. You can check it with a multimeter but I’m not sure what voltages you’re looking for.
Chris Johnson –
Anyone have the electrical schematic for the accelerator sensor I was getting the e24 code and I replaced the sensor itself and I reset the codes and stuff and it’s still coming up to e24
Andy Guild –
Here’s the best I can find for help with Code E-24: ForkliftAction
William –
I just purchased a 2012 nissan 40 forklift to use very little.
It was delivered Saturday and here Monday I was going to move a couple pallets of lumber around . And it flashing error code e24 . Idling a little higher but won’t shift out of neutral. Any thoughts?
Andy Guild –
You can check the accelerator pedal connection to the wiring harness. Should be connected just below the floor plate – check for looseness, debris and corrosion. There may also be a stop screw to adjust pedal travel that is out of range. And the accelerator pedal might have gone bad. You can check it with a multimeter but I’m not sure what voltages you’re looking for.